Drive Premium Guard Water Mattress Overlay
Drive Premium Guard Water Mattress Overlay

Drive Premium Guard Water Mattress Overlay

Brand/Manufacturer: DRIVE MEDICAL
Save
Authorized Retailer Badge
  • HyGiene Products
  • Non Returnable

Drive Premium Guard Water Mattress Overlay consists of three water baffles which enhances movement and support to reduce pressure and adapt well to various body weights. The filling lines and foot placement lines provide patient correct positioning. Its double sealed seams provide maximum amount of strength and durability.

Item #DescPkgPrice 
14400 32"W x 68"L x 4"H Each $60.99 $38.99

Features

  • Drive Premium Guard Water Mattress Overlay is constructed of vinyl which is durable and easy to clean with mild detergent
  • Fill lines are conveniently located
  • Weight capacity: 250lb
  • Note:
    -
    Do not elevate bed more than 20 degrees
    - This item cannot be returned or exchanged due to hygienic reasons

More Information

  • SAFEGUARDS:
    -Do not use hot water it could damage the mattress. Use warm water only
    -Do not overfill, the mattress should be filled with a minimum amount of water. The patients body should not be able to depress the top of the mattress enough to touch the bottom. Overfilling will diminish the pressure-reducing characteristics so vital to flotation therapy. Overfilling can also physically damage the mattress.
    -Avoid puncture by keeping pins and other sharp instruments away from the mattress.
  • STEPS TO ACHIEVING OPTIMAL COMFORT:
    - Unfold the mattress. Place it on the hospital mattress or conventional mattress with the Fill Valve visible at the foot of the bed.
    - Unscrew the Fill Valve cap. Holding the base of the Fill Valve, insert your finger into the opening and pull the valve to its raised position. Locate a nearby faucet to obtain warm water (approximately 98-99°F, 36-37° C). Water temperature should approximate body temperature.
    - Connect a standard type garden hose to the faucet. Screw the female end into the male Fill Valve.
    - Turn off the water when desired level has been reached. Do not overfill as this will cause excessive stress to the mattress and may cause seam leakage. If you accidentally overfill the mattress, drain out the excess water immediately
    -Mark date filled. 
  • DRAINING:
    - To drain the mattress, place the Fill Valve in the raised position and open it. Insert the female end of hose into the Fill Valve. Locate a drain at a point lower than the mattress, and then gently press down on mattress to start flow. After draining, rinse the interior of the mattress several times with water. Allow to dry. This product is a single-use product. 
  • CLEANING:
    - You may clean the mattress with any non-petroleum-based antibacterial cleaner. Do not autoclave. The mattress may be gas sterilized.
  • REPAIR KIT:
    - In the event of a puncture, you can repair the mattress while it is still filled. Remove the patient from the mattress and locate the hole. Dry the area with a towel and push glue into the hole from the inclosed Repair Kit. Allow the glue to dry for ten minutes. For larger cuts, use the glue and patch kit.

Warning WARNING: Cancer and Reproductive Harm - www.P65Warnings.ca.gov

Warranty

Limited 90 Days warranty on seams and valve

Customer Reviews

Questions & Answers


 
 
Please enter your and your friends email address below.
Fields marked with * are compulsory
 
*
*
*
*

 
SubmitCancel
The selected product information has been successfully emailed to your friend.

Thank you for using www.shopwheelchair.com

Close