Features
- Drive White Powder Coated Grab Bar comes in attractive retail packaging
- When mounted, sticks out 1.5" from the wall
More Information
- Mounting Instructions:
Note: Mounting flanges of grab bar must be aligned to mount to wall studs. Wood screws must go through the wall board or tile and attach to wood wall studs for solid support. For plastic tub and shower enclosures, drill through wall and mount grab bar to wall studs.
- Place grab bar on wall in line with wall studs and mark location of screw holes. After deciding on type of attachment, drill small hole to confirm the location of the stud. - Caution: Wood screws should only be used in wooded wall studs.
- Determine for each flange whether to use wood screws or toggle bolts. Warning: At least two wood screws in each flange must be attached to wall studs or grab bar may pull out and serious injury could result
- Use masonry bit to drill through tile or grout. For wood screws, drill small pilot hole into wood studs.
- After holes are drilled, place grab bar on wall and attach with wood screw. If using toggle bolts, make sure bolt is attached to grab bar flange before being forced into hole.
Note: Use caulking around grab bar flanges to prevent moisture from seeping in.
Note: Clean with mild soap and rinse with warm water.
- Tighten all screws and bolts with screwdriver. Check periodically for tightness. Never use grab bar if any looseness is detected as it could result in personal injury.
WARNING: Cancer and Reproductive Harm -
www.P65Warnings.ca.gov Warranty
Lifetime limited warranty Questions & Answers
 | ItemQuestion ItemName - now |
| Your question will show here once it will get approved. |
 | UserAnswer UserName - now Your Answer will show here once it will get approved. |
|